View Full Version : Technical Info
- Did/Do Mahle Pistons and cylinders come coated in Cosmoline?
- Different holes pattern between 'flag' and Durant mirrors?
- Fuel Line After Plating
- RS tires sizes and options
- 1967 Ingition switch bezel washers
- What is this attached to my shifter?
- Mike M on YouTube - 1967 911 Restoration
- Wevo shifter and parts for 901 transmission?
- Park Brake questions
- Bad oil for our engines
- Oil tank restoration
- wood dash refinishing
- Oil line pressure testing equipment
- favorite method for cleaning perlon ?
- Differences in 1972 oil tanks?
- 72 915 transmission - mating to engine lubrication question
- Original fan housing strap zinc coating started peeling. What are my options?
- 1966 correct headlights?
- Correct Koni shock top for 1973 S
- getting ready to buy tires - just need a little hand holding
- Wilhoits Colour samples
- 1969 vinyl question
- Leistritz Police: Please Confirm Year-Model Application!
- Help to date these door handles
- 4piston caliper upgrade for stock (11.4”) disks..
- Measurements of a 1972 911T (carbs) engine
- J-tube hose
- 67S steering wheel help - gersteen....
- 1966 door strikers?
- Thoughts on using a 911/01 vs 915 gearbox in front of a 2.8 twin, in a '68 SWB 911
- Help with dating these switches
- Ethanol 15% coming in June
- Where does this wire go?
- 1966 headrests
- Question about dimensions distance front latch panel
- Battery Question
- Paint correction
- What is paint on heater valves?
- Cigarette Lighter Help
- How to remove the tail light buckets
- Rear Bumper Corner Options
- headlight question
- back lamps, primer
- Is a '68 front crossmember a 1 year only item?
- E1 versus vvvvv K43210
- Heat exchanger experts, question
- Zeniths or Weber ?
- seat belt very hard to pull out (But not bob weight lock up)
- Are SSI's louder than stock heater boxes?
- Restoring Aluminium
- 1968 2.0T SWB German Car
- Protecting Magnesium
- 72 Bilstein struts to ball joint - wedge bolt question
- Rear bumper ID
- MFI pump fuel cut off solenoid
- Oil hose engine to tank
- Any experinces there with rebore alusil cylinders and replate them?
- M6X12 Engine sheet metal screws?
- Cold Start/Auxiliary Enrichment Circuit & Support Stand Questions
- Fuel Line help
- Engine weights
- 911T exhaust
- Targa seal replacement issue
- Trim width - 1972 MY 911
- Color differences in engine bay decals on 1973?
- Help - Engine Lid Seal
- 67S Sunvisors?
- Weld in exhaust pipes
- Part number / source for targa bar caps on either side of the alignment pin hole
- Crane cams
- Winter cover engine grill cover ?
- Removal of 71 wiring harness
- Question on this wire 1971
- Repairing a chip to the fan
- 904 LSD open heart surgery
- 72 911 - front stabilizer bar sizes/availability
- CV/axle question
- Hazard Switches
- Windshield spray nozzle installation
- DC30 vs DC40 Camshafts
- Porsche 911s 1967 model built 1966
- Difference in length of special SWB turbo tie rods vs standard, -anyone know?
- '68 battery tray location
- Why is my sport seat too big for a 1973 base?
- Recomendation: Piston Rings for 80mm Mahle
- 1969 radio face plate
- mud flap mounting
- Sports seats '72 911s
- '66 Engine Compartment Decals
- 911 rear side panels
- My plater lost my 1/4 window hardware
- ‘71T 2.2 HP upgrade options.
- 911 Carrera RS Rear Cross Panel
- Torsion Bar Tube End Repair ('69 911e)?
- Drive flange seal
- 72 911 ball joint torque - need confirmation please
- LWB Door Repair
- "Rebuilding" red trumpet horn?
- 1972 oil console connections
- Help me identify this piece of the window regulator
- Book Time to Replace Ball Joints??
- Can anyone identify this damper
- oil tank sending unit question
- Open air cleaners on 1969 911S MFI-
- Best new front windscreen
- 911S 67-10 Model 68 SWB
- Tyre pressure for 2.8 RSR
- prepurchase inspections in connecticut
- MFI warm air intake thingie - Do I need it?
- ‘73 air conditioner question
- Gearbox breather
- CoA on my 73s
- PMO carb starting issue
- Brake options for 71T - with stock spindles
- 1969 911S MFI Fuel Console mounting location
- Sun visors, what I have and what I need?
- Best 2-into-1 muffler for 2.7RS ?
- Seal at front engine compartment & Body ?
- 261 = Plain Drivers Side Mirror
- Jan 1966 does this look correct ??
- Question regarding front bumper deco molding for 67 911S (wide S version)
- Fan color
- More gear box number and type questions
- Speedo Angle Drive Set Screw into Transmission with Broken Helicoil
- Early roll bar dimensions
- Hella 128 fog lamps for 911s 1966 build
- I want to install an additional oil temp sensor...ideas?
- Adding an oil cooler to a '69
- Source for fuel pump rubber cover boot
- Cover color
- Fabric quantity question
- 1973 Brake pipes restoration
- Question for plating experts - rear bumper support
- Refinishing heater/Blower control unit
- correct seatbelt door panel for 1973 S
- 901 transmission question
- rear wiper shaft diameters
- Strut housing gland nut question
- Oil Cooler Differences and Markings Reference
- Seat differences between 911 and 912
- Interior Kits
- Webasto Parts Diagram?
- Garage air compressor
- 4 hole horn grill
- 911 targa f-model 1973: aircondition Behr repair
- Color codes
- Original suspension for 1973 911 S
- Wiper assembly installation
- Wiring loom for 1973 911S
- 1971 911S Help... Master Cylinder photos (installed) needed
- Clock with timer for external heater
- Front bumper deco orientation
- Door Seals
- Help me diagnose this gearbox drain plug debris
- Battery Box Question
- Front sway bar bushing install - question please
- Stripped Engine Case Hole
- A little SWB help (testers needed)
- Rain Shield
- correct 1966 seat belt?
- Heat Exchanger / Cyl Head Stud pulled-
- rear window defrost tubes
- my 1966 tool kit is incomplete
- Repaint question.
- Repo parts recommendations for '73 RS
- front suspension squeek
- Air Conditioning System Removal
- build date for 73 911E S/N 9113201025
- Are all Engine Lid hinges the same?
- seat belt receiver ... driver or passenger ?
- Why Might My Car Catch On Fire?
- Black leatherette seat material
- Help identify my 1968-1970 seat belt collection.
- what year rear seat back?
- 1966 correct struts and tops?
- Delta mark 10
- Tunnel Variations and adaptability?
- How to adjust Hardi fuel pump pressure
- 911T Engine-Fuel Recommendation
- 1972 blower drain
- Correct undercoating area on '67 911'S
- 1973 911S Targa Wiring loom taped or PVC sleeve ?
- Servicing Interstate Batteries
- new spare doesn't fit in the well
- Flasher relay for LED bulbs
- 1973.5 Rear Axle colour
- 1969T, Webers or PMO?
- Anyone ever see one like this?
- Wind noise A-pillar - How to fit this "bridge"-thingy?
- MFI fuel pump?
- Testing lights
- 1973.5 tool bag
- SWB Insert Help Needed
- Brake reservoir BLUE hose. Who sells it???
- '71 911S Pedal Assembly: What Is This Switch For?
- 10K tach 60,000 Imp
- 1971 911S Fuel Pump Area... Photos? Anyone??? ;o)
- Intermittent misfire
- Need A/C dipstick for '69 911 oil filler neck
- 73.5 Bumperette upgrade without "S" front spoiler
- Turn Signal Relay Switch
- MFI troubleshooting - high idle, pops and bucks at part throttle
- 1972T to ST conversion. Rear banana arm options?
- Kardex questions/ Mysteries
- Brake caliper questions
- Dashboard heater controls
- Gas tank anomaly ...
- Crank shaft
- MFI, idle speed slows down after coasting downhill
- SWB vent glass removal?
- Door pockets for not so deep pockets
- 1965-1968 rear window trim molding differences?
- 1965-1968 strut tops?
- Let's Make This Simple!
- 1969 911S trailing Arm Bushing replacement
- Restrictor fittings
- Under Body, Floor & Engine Bay Colors
- no oil in filter
- Caliper bolt spacing 1964-1973?
- Petronix Ignition
- 1967S rear view mirror assembly?
- 69 fuel level / oil level instrument compatible with 70 senders?
- Restoring contour to flattened hood crest
- Ignition Plug wires for 1971S
- date stamped body parts
- Window regulator pivot pin - replacement
- 67S Koni Steering Arm and Caliper Mount Color
- H+H Rear sway bar drop link bushings?
- late 68 Maintenance Record Booklet
- correct 1972 engine sound pad options?
- Targa window scrapers
- putty and oxidation
- Rebuilding a 2.2S engine - help re: "upgrades"
- Need help to identify a set of rear trailing arms
- Ignition switch bezels - what diameters?
- Help Mounting a Roof Rack
- 69 911s exhaust colors? Need help
- SWB front tender reproduction
- MFI Info
- Heater control valve parts
- Kienzle clock - repair mechanical or replace with quartz?
- Electronic Ignition Systems
- Charging Voltage Change with change to AGM battery’s?
- Magnesium stacks
- Top door trim difference
- Top door trim difference
- Engine stand
- Spark Plug Gap
- Correct Dist cap and rotor for 1971S 2.2
- Porsche Fender Gasket
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.