View Full Version : Technical Info
- What short bolts for seat belt brackets?
- early engine sound pad
- Drilling template for dead pedal
- 1973 911T converted to a 930 turbo look by the original owner- Help!
- H1 lens pitting repairs
- RS type seat ID steel frame
- Rubber bushings for LWB
- Removing Targa Bar
- Holes for gauges - SWB vs. LWB
- cross section pictures of longitudinals
- Oil line routing 69S
- Help identifying unknown engine part from 1972 911T
- workshop manual's body drawings
- Refurbishing Reflectors: Chrome vs. Aluminum
- Metric Weld Nuts
- 1980 911 SC gas tank into a 1968 Normale.........has anyone done this swap?
- cadmium plating
- 68 steering column details.
- '73 quarter window exterior trim installation
- Britax harness - To new for parts ?
- Weird oil leak at the fan belt pulley end of the engine
- Clarifications for door striker issue (72) please
- 1969 911S transmission - help to find the car it belongs to?
- Correct finish for 1972 tail light housing
- Need to replace glass on small (105mm) Durant mirror
- ID and value question: 7:31 915 trans
- Adjusting the tension on the MFI pump drive belt
- thickness of chrome bumper cover on rear at wheel well
- Where to buy heat exchangers
- Reproduction LWB armrest 69-73
- Wheel re-chromer needed close to Ontario border
- Early 911 Horns
- Non Porsche question - 6 Volt Hardi fuel pumps
- Steering Wheel ID Help?
- Help in replacing two hoses
- rubber/platic liner under aluminum door threshold
- 73 S - looking to contact Adam Burns re distributor rebuild
- Bilstein Sport shocks for SWB?
- '72 911T - No gaskets for MFI throttle bodies to intake ports?
- plastic RS tank does not fit ?
- Mechanical chain tensioner adjustment, how tight?
- H1 Archaeology
- Adjusting H1's
- Weber 40mm 3c rebuild/tuning book.
- 901 transmission rebuild video
- RS plastic tank venting set up - pics please
- RSR wheel lug nuts - Ti or steel
- how to separate front sway bar bushing from 3 hole tri plate?
- 1970 911E targa... help for wheels, roof, and paint
- 70 911E targa suspension
- Ate brake calipers
- SWB braket - what is it good for
- Momo Wheel Questions
- Paint Tag 67S Special Order Colour
- SWB Front Turn Signal Lenses
- Rear Jump Seat Bases Differences
- 1972 2.4s oil lines, help needed!
- 73 S - trunk lid underside finish?
- 1972 rear bumper front chrome cap attachment?
- Correct oil cap color ('67)
- Question about air cleaner housings and engine noise
- What kind of hub is this?
- Someone local to me ( Raleigh NC) to service/rebuild 910 transmission
- Leather steering wheel 420mm
- iPod/iPhone/MP3/aux and Frankfurt
- Reflectivity: Aluminum vs. Silver
- does this vin look 'funny'
- 1968 Armrests
- Correct jack for a 1972 911T
- Weber 40IDA3C & 40IDA3c1: idle jet carrier washer and idle mixture o-ring questions
- Lead Plugs in Webers
- Seat belts advice needed
- what sized odyessy matches and fits a 73?
- What seats are these?
- Anyone have experience disassembling a 5 bar engine grill?
- where to cut hole for 69 MFI adjustment?
- MFI, EFI, or Webers IDA 40 911S 1971 ????
- 68 911S information pleas.
- Battery charging
- which Webasto type is this?
- Stuck engine lid
- Mid rise lift opinions ?
- Outer sill chrome trim
- Front Bumper Brackets '73 US unique ?
- Engine not starting and no oil light on after engine installation
- HELP Strange VIN
- Recaro Idealsitz S
- emergency hazard flasher
- Knock-back mechanism on brake piston
- Prior chrome metal polishing
- 67S Horn Grill Seal
- correct early 911 rear fog light
- different type of Solex snorkels??
- original cloth tape on strut
- Help Identifying Wheels 5.5 x 14
- Flapper box restoration ?
- correct fitting of swb front dust shield /backing plate
- carb velocity stacks ? help ID
- Rebuilding plans for a 1973 911T
- What was the first date of production for MY 1968?
- 67, 68 911S Pressure Plate
- Headlight bucket removal
- 73 and earlier seats
- Windscreen washing bottle place on AC
- MFI restoration
- Restoratin of tail, and signal light`s
- 1967 911S Mufflers
- Fitting wide S rocker deco around jack receiver
- Closest paint colour to standard Fuchs anodised finish?
- Images of 185/70HR15 Vredesteins on 15x7s
- 3D printing
- Rear Window Size
- Porsche 911 2,2 S engine wire
- Nadella Shaft restoration
- Suggestions for restoration/enhancement of original paint?
- installing retractable belts
- switch id - 901.613.045.00
- 1972 911S cold start circuit
- correct color of the lamp and horngrill seals
- Correct 1969 911E Batteries
- piston and cylinder sets - the big question
- Bezel and Interior Door Handle Chalking
- The Exploding Pirelli Spare tire Trick
- Are Heads position dependent ?
- Question concerning 15 x 7 Fuchs
- Wiring Harness's???
- Activate the horn with Hockey puck/Batwing
- How to install small rings holding blower halves together?
- Engine Number 6210800
- Leistritz versus Dansk
- Torsion Tube Dimensions from Workshop manual
- dash switch bezels plastic or metal chrome?
- Yellow finish for the S caliper
- 1973 911 T Hazard Light Decal/Label
- 65 metal work restoration
- Aftermarket Bosch MFI Fuel Pump
- engine -transmission question
- Roll Bar Help
- 1965 seats question
- ignition switch diameter
- Can I wire wheel my fan blade?
- Oil Temperature/Pressure Gauge p/n
- '72 911T - Cylinder 5 misfiring after rebuild
- Help identifying parts
- '66 911 front hood release... won't
- SWB Rear Hubs
- Help to chose correct paint for Oil tank
- Proper Restoration of SWB Oil Tank
- Changing the oil pressure sending sensor
- Correct Paint Details for 1967
- QSC Headers?
- Help ID this part?
- Fresh air Bowden cable bolt ID
- 72 oil line question
- Question on Wurth finish for Gas Tanks
- 1970 S upper valve covers
- 72 Engine wire harness question
- swb or lwb racecar? pleasure, price etc
- 1973 Oil Tank Questions
- Proper finishes for a 73
- Take apart deck lid grill.
- 1972 911T CV Bolt Clamp
- Steering Wheel Question
- Euro Ignition Switch change to USA type
- Strange RPM instrument 66.9
- '67S non-radio factory configuration?
- Massaged rods....
- Interior code question /66 - trying to pick the right leather for '72 seats
- Speedometer Conversion
- Jetting recommendations for 2.2 E spec engine w/ Webers?
- Old Orange Bar Hood Crest Badge... replacement posts?
- Looking for information on Rapid Cool oil cooler for Porsche 911
- Suggestions for repairing pinholes in muffler?
- Need scan / copy of early wiring diagrams
- Rear Tow Hook, 911 ~ Hardware?
- Early electric antenna and factory fender oil cooler, conflict?
- What is this on the KYB shock?
- original 1965 safety belts: what do they look like
- Oil-Filled Front Shocks on SWB?
- Blaupunkt radio plate
- Switch Bulbs
- rotating M caliper pistons
- replacement antenna 71
- May need a new muffler, what are my options?
- "AT" 911/01 Transmission ID
- Owners Manual Binder Coil... where to get?
- Sourcing Early Turn Signal Lenses
- 1971 911 need gauge wiring diagram
- RS vs. S-spec cams?
- Old race/rally seat model year?
- Seat Belts for 70
- shift slop
- Outside mirror recommendations for 1969 911T
- Wood Dash Clip Removal
- wiper mechanism question
- Replacing my Bosch CDI in my 73T
- starter motor
- MFI prime?
- Help to Identify This Chassis Badge
- SWB Temp Gauge Placement
- ultimate head light thread?
- Fire Extinguisher Recommendation
- Wiring 902.613.511.91 switch
- "72 -"73 Cold Start plastic "Tee" fitting for mechanical injection
- Remove quarterlight glass?
- Horn: Save or replace ?
- Repair or Replace Leaking Valve Covers?
- Brakes Issue?
- how close does an engine number need to be for a 'close' to matching' engine?
- 68 only Smog Stuff, what do you call this piece?
- Build date for my '70E??
- Reproduction of Bosch RPM Transducer Sticker?
- 1970 911 e euro Italy headlights
- 2.0 engine advice / help !
- can aluminum trim pieces for windshield be reused
- Wiper L to R park flip
- front bumper seal installation
- front bumper seal installation
- 73 S - sport seat and seat mounting rail questions
- Weber anti-percolation revisited
- Welder in the Bay Area?
- will new American Racing Thurst torq D...
- Need help identifying cams
- Where to buy the best SWB head liner?
- Signal/wiper cluster removal
- Seat belt ideas
- Leather steering restoration?
- what does SPM mean in Model collumn of Parts catalog ??
- Calipers bolt spacing
- New rubber
- Help Cylinder ID 80m
- Early door card material, where can I find it
- Hi, please help with identifying these, thanks
- Halon fire bottle removal - question please
- Door flew open
- Black Paint around perimiter of doors - example photos please?
- Twin plug mfi ignition question
- 1972 porsche 911 oil tank
- wevo engine mounts ALL 4
- What part is this and what does it go to?
- Rear suspension rebuild
- Need help with seat re-assembly
- Porsche Classic Approved Tire Table
- "Kraftfahrzeugbrief"
- Questions about 1969 dash bits
- 2.2T converted back to 2.0T
- 73S - base/clear painting detail question....
- Color code fan shroud
- Black paint under rocker panel
- Auto detailing my paint
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.